Small squares appear again: place the cursor to one of them and then release the button. Click on of them and by holding the mouse button down, move the cursor to another picture you want to connect to. Now, to connect the components, place the cursor over a picture: a small square appear in the center of each side. In an electronic circuit, the connectors with circles is commonly used In the Drawing toolbar (by default located at the bottom) for two seconds: a choice of several connectors is displayed. To connect the components (create connections), click the Connectors button.To rotate the picture, use the red circles located at each corner of the picture: click one of them and move the mouse. To do so, click the Effects button.Ī black circle appears in the center of the picture: it is the center of the rotation that you can move. ![]() Note: you can also use the Drawing toolbar (by default located at the bottom). Select the Rotation tab and choose the angle in the Rotation Angle section. To rotate a picture, right-click on the picture and in the context menu that appears, click the Position and Size command.In the first tab ( Position and Size), increase or decrease the value of the Position X field (horizontal direction) and the Position Y (vertical direction). To easily move a picture, right-click on the picture you want to move and then in the popup menu that appears, click on the Position and Size command (or simply press F4).Once all your symbols have been inserted into your document, organize them and move them in order to begin to connect them. ![]()
0 Comments
Leave a Reply. |